PRG S400 User Manual 3.1 - Manual (Page 39)

PRG SERIES 400 ® POWER AND DATA DISTRIBUTION SYSTEM USER MANUAL 33
Breakout Box Mounting Options
Breakout Boxes can be hung horizontally or vertically from any appropriate truss or structure. The Breakout Box
provides threaded holes for mounting by wingbolts, along with two additional holes for attaching a clamp bracket or a
variety of other hooks. The Mega-Claw truss hook is shown in these examples, however, other compatible truss
hooks are available from different manufacturers.
CAUTION: A safety cable should be used in all mounting configurations. Attach as shown.
Wingbolt
Wingbolts are provided for mounting on standard 2-inch round truss pipe.
Figure 2-13: Wingbolt Mounting Method
Clamp Bracket Rail
In order to accommodate other mounting hooks, a clamp bracket rail (also used with VARI
❋LITE® Series 1000™,
2000™ and 3000™ luminaires) can be attached. The bracket requires two bushings, screws, nuts and the bracket
itself (refer to
"Accessories" on page 12 for part numbers).
Figure 2-14: Installing Clamp Bracket
Wingbolts
Truss Pipe
Breakout Box
15A 208V MODEL SHOWN
Rack Components May Vary
Attach safety cable
at two hole locations
Safety Cable
SIDE VIEW
Bracket
Truss Hook Hardware
(not provided)
Bracket
Bushing
Locking Mechanism
Press up when
installing or releasing
Truss Hook
(not included)
Screw
Nut
1. Install bushings.
2. Install bracket, locking into place.
3. Install truss hook.
Procedure: