Potter PFC-6075 - Manual (Page 43)

3-37
PFC-6075 • 5403593 • Rev C • 2/13
Setting Addresses
The FCB-1000's address is set by dip switch S1. The address must be set in the range of one (1) to thirty-one (1–31) to be
recognized by the panel. (Refer to the "P-Link Addresses" table shown earlier in this section for DIP switch programming.)
FCB-1000 Back Panel View Showing Dip Switch Location Figure 46.
Fiber Interface Bridge Installation (FIB-1000)
The panel supports up to thirty (30) FIB-1000s (Fiber Interface Bridge), which enables the 4-wire P-Link bus to be converted to
and/or from the fiber optic cable.
Utilizes multimode 62.5/125 micron fiber optic cable •
Cable Length up to 2000 meters or 6500 feet •
Installed in pairs ( • refer to the "FIB-1000 Wiring" heading for details)
The first installed FIB-1000 can be mounted into any of the compatible fire enclosures, in either of the Ae-8 or Ae-14, or the
optional rack-mount kit (FIB-1000RM). The FIB-1000RM includes a standard 19 inch rack-mount enclosure, which can then be
installed directly in an equipment rack. The second installed FIB-1000 must be installed in a PSN-1000e cabinet as illustrated in
the following drawings.
FIB-1000 Bridge & FIB-1000RM Rack Mount Figure 47.
DWG #608-11 DWG #608-12
Dip Switch
DWG #608-20
P-Link
Connections
S1