Potter PFC-6075 - Manual (Page 112)

6-106
PFC-6075 • 5403593 • Rev C • 2/13
Municipal Box Connection
When the PSN-1000/PSN-1000(e) is programmed as a municipal box connection, the circuit is power limited and supervised for
open and short circuit conditions. It also provides a local energy connection. Please refer to the figure shown below for a wiring
example.
Configuration Characteristics
NAC1-NAC6's trip current is 3 amps. y y
Maximum voltage rating is 24 vDC. y y
Notes:
The panel has ground fault detection on municipal box connection circuits. 1.
The impedance to ground for ground fault detection is 0 ohms. 2.
PSN-1000 Configured as Municipal Box Figure 147.
- I1 + - NAC 1 + - NAC 5 + - NAC 3 +
-
+ A B
- I2 + - NAC 2 + - NAC 4 + - NAC 6 +
-
+ A B
P-LINK
Notes:
The EOL device shall be installed in the same electrical
enclosure as the Municipal Box.
Municipal
Box
+
-
End of line device
5.1k ohm 1/2W
Part #3005012
Relay Outputs
The board has two (2) relay outputs: a dedicated Trouble relay and a Low AC relay. The dedicated Trouble relay is a failsafe
trouble relay that changes position anytime a trouble condition occurs.
The relays have a contact rating is 24vDC / 3.0A, 125vAC / 3A, and a Power Factor of 1.0. These outputs are non-power limited
and are not supervised.
Note: If the power supply is power-limited, then the outputs are power limited.
PSN-1000's Relay Outputs Figure 148.
LOW AC
NC COM NO
TROUBLE
NC COM NO
DWG #602-31
DWG #602-32