Interlogix NX-8E Installation Manual - Manual (Page 51)

Chapter 2: Reporting codes
NX-8E Control Panel Installation Manual 47
Location 98
Partition 5 account code Location 98 has six segments of numerical data. If the
account code is less than six digits, program a 10 in the
segment immediately after the last digit of the account
number. If the account code is six digits long, program
all six segments.
Location 99
Partition 5 feature and reporting
selection Location 99 has five segments of feature selection data.
Use this location to enable certain features that are
accessed or visible to the user from the system keypad.
In addition, certain communicator reports are enabled at
this location. Each of these features can be enabled by
partition (Location 23).
Location 100
Partition 5 entry and exit times Location 100 has six segments of numerical data. Use
this location to program the entry/exit times for partition
5. There are two separate entry/exit times (Location
24).
Location 101
Partition 6 account code Location 101 has six segments of numerical data. If the
account code is less than six digits, program a 10 in the
segment immediately after the last digit of the account
number. If the account code is six digits long, program
all six segments.
Location 102
Partition 6 feature and reporting
selection Location 102 has five segments of feature selection
data. Use this location to enable certain features that
are accessed or visible to the user from the system
keypad. In addition, certain communicator reports are
enabled at this location. Each of these features can be
enabled by partition (Location 23).
Location 103
Partition 6 entry and exit times Location 103 has six segments of numerical data. Use
this location to program the entry/exit times for partition
6. There are two separate entry/exit times (Location
24).
Location 104
Partition 7 account code Location 104 has six segments of numerical data. If the
account code is less than six digits, program a 10 in the
segment immediately after the last digit of the account
number. If the account code is six digits long, program
all six segments.
Location 105
Partition 7 feature and reporting
selection Location 105 has five segments of feature selection
data. Use this location to enable certain features that
are accessed or visible to the user from the system
keypad. In addition, certain communicator reports are
enabled at this location. Each of these features can be
enabled by partition (Location 23).
Location 106
Partition 7 entry and exit times Location 106 has six segments of numerical data. Use
this location to program the entry/exit times for partition
7. There are two separate entry/exit times (Location
24).
Location 107
Partition 8 account code Location 107 has six segments of numerical data. If the
account code is less than six digits, program a 10 in the
segment immediately after the last digit of the account