Location 84 - daylight saving time – Interlogix NX-8E Installation Manual User Manual

Page 48

Chapter 2: Reporting codes

NX-8E Control Panel Installation Manual

Location 72
Telephone line cut/restore
communicator code

Program the digits sent for a 4+2 format if telephone
line cut reporting is enabled.
Segments 1 and 2 = telephone line cut reporting
Segments 3 and 4 = telephone line cut restore.

Location 73
Ground fault/restore communicator
code

Program the digits sent for a 4+2 format if ground fault
reporting is enabled.
Segments 1 and 2 = ground fault reporting
Segments 3 and 4 = ground fault restore

Location 74
Expander trouble/restore communicator
code

Program the digits sent for 4+2 format if expander
trouble reporting is enabled (Location 37).
Segments 1 and 2 = expander trouble tamper;
Segments 3 and 4 = expander trouble restore.

Location 75
Fail to communicate communicator
code

Program the digits sent for a 4+2 format that are sent if
the fail to communicate reporting is enabled (Location
37).

Location 76
Log full communicator code

Program the digits sent for a 4+2 format if the log full
reporting is enabled (Location 37).

Location 77
Opening communicator code

Program the digits sent for a 4+2 format if the opening
report is enabled (Location 23) for each partition (1 to
8).

Location 78
Closing communicator code

Program the digits sent for a 4+2 format if the closing
report is enabled (Location 23) for each partition (1 to
8).

Location 79
Autotest communicator code

Program the digits sent for a 4+2 format if the autotest
or manual test is enabled (Location 37).

Location 80
Recent closing and exit error
communicator code

Program the digits sent for a 4+2 format if recent
closing and/or exit error reporting is enabled (Location
23). Segments 1 and 2 = recent closing report
Segments 3 and 4 = exit error reporting

Location 81
Start program and end program
communicator code

Program the digits sent for a 4+2 format if start/end
programming reporting is enabled (Location 37).
Segments 1 and 2 = start program reporting
Segments 3 and 4 = end program reporting

Location 82
End download communicator code

Program the digits sent for a 4+2 format if end
download reporting is enabled (Location 37).
Segments 1 and 2 = Reserved
Segments 3 and 4 = end download reporting

Location 83
Cancel communicator code

Program the digits sent for a 4+2 format if cancel
reporting is enabled (Location 23).

Location 84 - Daylight saving time

Location 84 has four segments of numerical data. Use this location to program
when daylight saving time begins and ends. This will happen at 2:00 a.m. on the