Interlogix NX-8E Installation Manual User Manual
Page 26
Chapter 2: Reporting codes
22
NX-8E Control Panel Installation Manual
Location 8 - Phone 2 communicator format
Location 8 has one segment of numerical data. Use this location to program the
communicator format used to transmit to the receiver connected to phone 2.
Refer to your central station receiver documentation to determine which format is
compatible. Table 6 on page 19 describes the formats for this location. If you
need a format other than those listed, review the override options described in
Location 18. Program a 15 to create a special format (in addition to the entries in
Location 18). The default is 0. If this location contains a 0, format 1 will be used
when phone 2 is dialed.
Location 9 - Phone 2 dial attempts/backup control
Location 9 has two segments of numerical data.
Segment 1 - Phone 2 dial attempts
Program the number of dial attempts (1 to 15) the communicator makes to phone 2 before ending
the notification process. The default is 8, which means that the communicator makes eight
attempts to the first number.
Segment 2 - Phone 2 backup control
Program the backup control for phone 2. The default is 0.
0 = The NX-8E will make the designated number of attempts to phone 2 before setting the fail to
communicate condition to stop reporting.
1 = The NX-8E will stop trying to communicate after the designated number of attempts have
been made to phone 2.
2 = The NX-8E will make the dial attempts in increments of two. The first two attempts are made
to phone 2, the next two attempts to phone 1. This repeats until the total number of attempts
designated in segment 1 is completed.
Location 10 - Phone 2 events reported
Location 10 has two segments of feature selection data. Use this location to
select those events reported to phone 2.
• If you do not want dual or split reporting, use the default of 0.
• If you want dual or split reporting and the split is based on the event type
(alarm, open/close, etc.), use only those events that are reported to phone 2.
• If you don’t want events reported to phone 2, program 0 in Location 10.