Compaq PROLIANT 3000 - Manual (Page 60)

3-26 Rack-Mount Server Installation
Writer: Tom Erber Project: ProLiant 3000 Setup and Installation Guide Comments: 296908-002
File Name: D-CH03.DOC Last Saved On: 3/10/98 9:30 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Figure 3-16. Attaching the cable management arm to the rear brace of
the rack
Attaching the Optional
Cable Support
The optional cable support attaches to both sides of the rack’s rear. All cables to
and from the server are tied to this support, which allows the server cables to
stretch from the right rear of the server across to the cable channel on the other
side of the rack, where the other cables are all bundled in the cable channel.
The cable support is needed only if you intend to route cables from one side of
the rack to a cable channel on the other side of the rack.
Attach the cable support to both rear braces of the rack using four
M6 x 1.0-12L Phillips screws.