Flintec MCS-64 CANbus - Manual (Page 28)

Page Manual MSC-64 28
Part B
4 COMMANDS
These pages describe the ASCII commands as they must be used by the DOP software.
For each command the equivalent CAN-index and sub-index are shown in brackets [ … ]
for reference.
For better clarity, all commands are divided into groups as described on the following
pages.
4 COMMANDS
.............................................................................................................. 28
4.1 System diagnosis Commands – ID, IV, IS .............................................................. 29
4.2 Calibration Commands – CE, CM, CI, DS, DP, CZ, CG AZ, AG, ZT, FD, CS ........ 30
4.3 Motion detection Commands – NR, NT .................................................................. 34
4.4 Filter setting Commands – FM, FL, UR................................................................... 35
4.5 Set Zero/Tare and Reset Zero/Tare Commands – SZ, RZ, ST, RT........................ 37
4.6 Output Commands – GG, GN, GT, GS................................................................... 39
4.7 Setpoint Commands - Sn, Hn, An........................................................................... 40
4.8 Trigger Commands – SD, MT, GA, TE, TR, TL ...................................................... 42
4.9 Trigger Special Commands– RW, TT, TS, DT, TW, TI, HT .................................... 45
4.10 Communication setup Commands – AD & BR........................................................ 48
4.11 Save calibration, setup and setpoint parameters Commands – CS, WP, SS......... 49
4.12 Filling Commands – PD1 to PD21, DI, SC, AC, GD, DT, SD.................................. 50
4.13 Loss in Weight Commands – PL1 to PL5, LC, LI, GF, GR, GM............................. 51
4.14 Speed Estimation Multi-Channel System MCS-64 ................................................. 52