Flintec MCS-64 CANbus - Manual (Page 18)

Manual MCS-64 Page 18
Index Sub-
index Name Type Attri-
bute Default-value Meaning
2200 -
223F
for
LDM
0..63
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
Number of entries.
1
st
Parameter
2 nd Parameter
3
rd
Parameter
4 th Parameter
5
th
Parameter
6
th
Parameter
7
th
Parameter
8
th
Parameter
9
th
Parameter
10
th
Parameter
11 th Parameter
12
th
Parameter
13
th
Parameter
14
th
Parameter
15
th
Parameter
16
th
Parameter
17
th
Parameter
18 th Parameter
19
th
Parameter
20 th Parameter
21
st
Parameter
UI8
I32
I32
I32
I32
I32
I32
I32
I32
I32
I32
I32
I32
I32
I32
I32
I32
I32
I32
I32
I32
I32 ro
rw
rw
rw
rw
rw
rw
rw
rw
rw
rw
rw
rw
rw
rw
rw
rw
rw
rw
rw
rw
rw 19 Number of filling parameters.
Pre-fill mode
Correction factor for in-flight value in percent. Range: 0..50.
Zero check average time (in milliseconds)
Tare delay (in milliseconds)
Tare average time (in milliseconds) 0= Tare off
Delay after pre-fill (in milliseconds).
Blanking time (in milliseconds) after coarse valve shuts OFF
In-flight delay time (in milliseconds)
Dosed weight average Time (in milliseconds)
Zero tolerance (in increments).
Tare reference (in increments).
Tare tolerance (in increments).
Pre-fill level (in increments). Set-point for 1
st
pre-filling.
Fine-fill weight (in increments)
Filling weight (in increments).
In-flight value (in increments).
Pre-fill level (in increments). Set-point for 2
nd
pre-filling.
Fill timeout value (in milliseconds)
Underweight post fill time
Tare interval – the number of fillings per tare measurements
Bad rupture blanking
22FF
0
Number of entries.
As for 2200-2263 UI8
Ro
wo 17 Number of filling parameters.
As for 2200 – 223F, except this is WRITE ONLY and the settings are
broadcasted to all LDMs.