Flintec MCS-08 - Manual (Page 43)

MCS-08 Technical Manual, Rev. 1.04 December 2012 Page 43 of 52
11. MCS-08PN
–
P
ROFI
N
ET
G
ATEWAY
The MCS-08PN gateway module integrates up to 8 pcs. MCS-08AD A/D Converter modules and up to 8 pcs.
MCS-08IO Digital I/O modules to an external ProfiNet network. The MCS-08PN gateway module
communicates with other MCS-08 modules via the internal N-bus and responses to the PLC via ProfiNet.
The GSD file is available on a CD which is supplied together with the instrument.
11.1. Front View
There are 6 status LEDs on the front panel which indicate the operational module status (Refer to table 11.1)
and the ProfiNet status. The setup switch on front panel of the module is used for N-bus addressing without PC
(Refer to chapter 5.6) and for diagnostics (Refer to chapter 15).
When the error LED is ON, the other two LED indicate the error type (Refer to chapter 14 for details).
ProfiNet connection, power supply and serial interface terminals are located at the front of the DIN rail mount
module (See figure 11.1).
Status LEDs
ProfiNet connector
RS-232C connector
Setup Switch
Power Supply Terminal
Figure 11.1 – Front view
The meanings of these LEDs in operation are described below.
Status LEDs
Symbol Name Description
Pwr Power
Module is energized
Module is de-energized. Check power cable
Lnk Link
Communication takes place
No communication
Err Error
Error. Refer to error table in chapter 14
No error
Off On Off for 0.3 seconds
Table 11.1 – Status LEDs