Flintec MCS-08 - Manual (Page 13)

MCS-08 Technical Manual, Rev. 1.04 December 2012 Page 13 of 52
4.2.3. Digital I/O Connection
MCS- 08IO modules have the digital I/O connectors on the module‟s front. The I/O connection diagram is shown
in figure 4.5. The outputs are potential-free contacts (1A @ 250 VAC, 30 V DC) and the inputs are opto-isolated
(12…30 V DC).
Figure 4.5
– Digital I/O connection
4.2.4. Communication Interfaces
Please refer to the corresponding chapter:
MCS-08MB (Modbus RTU) see chapter 9.2
MCS-08PB (Profibus) see chapter 10.2
MCS-08PN (ProfiNet) see chapter 11.2
MCS-08EN (Ethernet and Modbus TCP) see chapter 12.2
4.3. Commissioning
PRECAUTION: Please read this manual carefully before energizing the instrument. Perform the commissioning
operation according the procedure given in this chapter. Only trained persons are allowed for cleaning,
commissioning, checking and servicing of the instrument. The interference of untrained person may cause
some unwanted damages or injuries.
Before energizing the instrument, please make the required mechanical and electrical installations. After power
on, you have to setup your MCS-08 system before you can start to use the bus interface.
Install the xFace software onto your PC as described in chapter 5 Setup. The xFace software is used for setup,
calibration and testing of MCS-08 systems.
After you have successfully checked the performance of the instrument with xFace, you can begin to use the
system in your application.
M C S -0 8 IO m o d u le M C S -0 8 IO m o d u le