Flintec DAS 72.1 - Manual (Page 49)

A2 Request / Set the Base for logic output 1,2 or 3
The A1 command defines the Base on which the setpoint value acts. If A1 is set to “0” then setpoint 1 acts
on the unfiltered gross weight. If A1 is set to “1” then setpoint 1 acts on the unfiltered net weight.
A1 = 0 Not filtered gross weight
A1 = 1 Not filtered net weight
A1 = 2 Peak value
A1 = 3 Average value
A1 = 4 Hold value
A1 = 5 Peak to Peak value
A1 = 6 Valley value
A1 = 7 Error message for ERROR 4/5
A1 = 8 Output diabled
Request / Set Base for logic output 1
Master ( PC / PLC ) sends DAS 72.1 responds Result
A1
¿
0+00000 Allocation gross weight
A1_1
¿
OK Allocation net weight
Similarly to read or set the logic output 2/3 Base, use A2/A3 instead of A1.
NOTE: All changes to the setpoint settings have to be stored in EEPROM using the SS command. See
section 4.13.
Manual DAS 72.1 Page 49