Special instructions, Installing the device driver – Comtrol Multiport Modems Windows NT User Manual
Page 8
Driver and Adapter Information
8
Special Instructions
7.
Select the Yes button to shut down and restart the system, so that your
changes take effect.
8.
After removing the existing driver, see the Installing the Device Driver
discussion.
Note: This procedure does not remove the Comtrol RocketPort RocketModem
program group. If you wish to do so, see the “Start Menu” topic in the
Windows NT help system for more information.
Special Instructions
If Comtrol RocketPort,RocketModem does not appear in the Adapters tab, select
Cancel to exit from the Network window. Then start the Comtrol RocketPort/
RocketModem Setup program, set the droplist for each board to Not Installed, and
save the changes and reboot.
This should remove the driver and clean up all associated files. If it does not
resolve the situation, contact Comtrol
for more assistance.
Installing the Device Driver
Use the following instructions to install the RocketPort/RocketModem Windows
NT driver.
Note: If you are updating the Windows NT driver, remove the existing driver first.
Do not use the Update option.
These procedures assume that you have already installed the hardware and
determined that it is working properly. If you have not done so, you can use the
Hardware Installation Document
for help in installing the hardware.