Comtrol Multiport Modems Windows NT - Manual (Page 26)

26
Installing and Configuring RAS
Installing and Configuring RAS
After installing the hardware and driver, and installing and configuring at least
one RAS device (for example, a modem), use this section to install and configure
Remote Access Service (RAS).
Installing RAS
Initially If you have not previously installed RAS in your Windows NT system, log into the
system with Administrative rights and follow these steps:
Note: This example shows how to install and configure RAS for use with modems,
but you can use it as a guide to setting up other serial devices.
1. Open the Control Panel and double-
click the Network icon, or right-click
on the Network Neighborhood and
select the Properties button.
2. Select the Services tab, and select the
Add button.
3. Highlight Remote Access Service,
and select the OK button.