Comtrol Multiport Modems Windows NT - Manual (Page 13)

Driver and Adapter Information 13
Driver Installation
Note: If you are installing more than one adapter, install all PCI-bus adapters
before installing any ISA-bus adapters.
13. If you have installed a RocketPort adapter that is capable of speeds over 230.4K
bps, you can configure the driver for high-speed operation at this time. Follow
these steps:
a. Select the Options tab.
b. Use the Scan Rate droplist to select a driver servicing rate. For example, to
use an Octacable at 460.8K bps, select 4. To use a RocketPort Plus at
921.6K bps, select 2 or 1.
For more information about the Options tab and Scan Rate control, see
Changing or Viewing Driver Configuration .
c. Select the Main Setup tab. The Device Setup tab reappears.
14. Select the OK button to close the Setup window.
15. Select the Yes button when the confirmation window appears, asking you to
verify that you want to save the configuration and exit. The setup process
creates and displays the program group:
16. Select the OK button when this reminder appears.
17. Select the Close button when the Network Adapters window appears, showing
the Comtrol adapter.
18. Select the Yes button to shut down and restart the server, or the No button to
put it off until a more convenient time.
Note: You must shut down and restart the server before your changes take
effect. Do not use the Comtrol Setup program until you have done so.