Comtrol Multiport Modems Windows NT - Manual (Page 30)

30
Adding or Reconfiguring a RAS Device
12. If you select TCP/IP, the following window appears. Make the appropriate
selections for your environment and press the OK button.
13. If you select IPX, the following window
appears. Make the appropriate selection for
your environment and select the OK
button.
14. Select the OK button to exit the Network
Configuration window and return to the
Remote Access Setup window.
Note: Choices made during network
configuration will effect the entire
system.
15. If you want to duplicate the configuration
you just created on any other COM port
(modem), highlight the COM port number
and select the Clone button. Otherwise, repeat
Steps 7 through 14 for each
COM port (modem) you want to set up.
16. After setting up all the COM ports, select the Continue button.
17. Select the Close button at the Network/Services tab to complete the RAS
installation.
18. Select the Yes button when asked to reboot the computer. Windows NT RAS
installation is complete.
19. If necessary, install the latest NT Service Pack or Packs from Microsoft.