Comtrol Multiport Modems Windows NT - Manual (Page 11)

Driver and Adapter Information 11
Driver Installation
8. Select the Next button when the Add Device Wizard appears and follow the on-
screen instructions to configure the adapter type you installed in your system.
You must install and configure at least one adapter at this time. If you are
installing more than one adapter, install all PCI-bus adapters before installing
any ISA-bus adapters.
Depending on the model of adapter you have installed, enter the following
information.
Note: The prompts that display and the options associated with each prompt
change depending on your selections. If you reach a point where the
available options do not match your product, you probably selected an
incorrect choice on an earlier page. In this case, select the Back button to
backtrack and review your selections, and correct as needed.
a. Bus Type. Select ISA or PCI, and select the Next button.
b. Model. Use the droplist to select the Comtrol product you have installed,
and select the Next button.
c. Number of Ports. Use the droplist to select the number of ports on the
product you have installed, and select the Next button.
d. Base I/O Address. (ISA-bus products only.) Use the droplist to select the
I/O address you set using the DIP switches on the adapter. (See the
Hardware Installation Document .)
If you are installing a PCI adapter and this prompt appears, you selected
the wrong Bus Type in Step a. Select the Back button to go back and change
your selection.
e. Country. (Comtrol modem products only.) Use the droplist to select the
country or region where the modem will be used.
Note: Not all Comtrol modem products support all country selections.
Check your packaging to make sure that your modem supports the
country you wish to select.