Select the close button, Further modem configuration – Comtrol Multiport Modems Windows NT User Manual
Page 25
25
Further Modem Configuration
8.
Select the Finish button. The modem software is installed on the selected ports.
Depending on prior configuration, you may be asked to enter your country of
use, area code, the number you dial to get an outside line, and whether you
have tone or pulse dialing at this time.
9.
If you need to configure modem
properties (maximum baud rate, data
bits, parity, and so on), select the
Properties button, make the needed
changes, then select OK to return to this
window.
Note: For help configuring modem
properties, see the Windows Help
System.
10. If you need to configure dialing
properties (country, area code, calling
card number, and so on), select the
Dialing Properties button, make the
needed changes, then select the OK
button to return to this window.
11. Select the Close button.
Further Modem
Configuration
At this point:
•
If you are not using RAS, you are now finished. Reboot the system so that your
changes take effect and resume normal operations.
•
If you plan to use RAS but do not have it installed yet, reboot your system,
then go to
•
If you already have RAS installed and configured, this dialog box appears.
If you do not want to configure this modem for use with RAS at this time,
select the No button, then reboot and resume normal operations.
If you do want to configure this modem for use with RAS, do not reboot.
Instead, select the Yes button, then go directly to
.