Comtrol ES7510-XT User Manual
Page 94
94 - VLAN Configuration
RocketLinx ES7510-XT User Guide: 2000571
Rev. D
Configuration Using the Web Interface
The following figure shows a static VLAN configuration table. The new VLAN 3 was created and the VLAN
name is test. Egress rules of the ports are not configured.
VLAN Configuration Page
Management VLAN
ID
The management VLAN ID is the VLAN ID of the CPU interface so that only member
ports of the management VLAN can ping and access the switch. The default
management VLAN ID is 1.
Click Apply after you enter the VLAN ID.
Static VLAN
You can assign a VLAN ID and VLAN Name for the new static VLAN.
•
VLAN ID: This is used by the switch to identify different VLANs. A valid VLAN ID
is between 1 and 4,094, 1 is the default VLAN.
•
VLAN Name: This is a reference for the network administrator to identify different
VLANs. The VLAN name may up to 12 characters in length. If you do not provide a
VLAN name, the system automatically assigns a VLAN name
•
. The rule is VLAN (VLAN ID).
Click Add to create a new VLAN. The new VLAN displays in the Static VLAN
Configuration table. After creating the VLAN, the status of the VLAN remains Unused,
until you add ports to the VLAN.
Note: Before changing the management VLAN ID by web or Telnet, remember that the
port attached by the administrator should be the member port of the management
VLAN; otherwise the administrator cannot access the switch through the
network. The ES7510-XT supports a maximum of 256 VLANs.
Static VLAN
Configuration
•
VLAN ID: The VLAN identifier for this VLAN.
•
Name: The name of the VLAN.
•
1 - 10: The corresponding port number on the VLAN.
•
-- Not available
•
U Untag, indicates that egress/outgoing frames are not VLAN tagged.
•
T Tag, indicates that egress/outgoing frames are
•
LAN tagged.
•
Click Apply to apply the settings.
Note: You must Save the settings (
), if you want to maintain these settings
if the ES7510-XT is powered off.
•
Click Remove to remove the selected static VLAN.
•
Click Reload to reload static VLAN configuration.