Connect sfp transceivers (combo ports 9-10), Led descriptions – Comtrol ES7510-XT User Manual
Page 14
14 - Connect SFP Transceivers (Combo Ports 9-10)
RocketLinx ES7510-XT User Guide: 2000571
Rev. D
Hardware Installation
Connect SFP Transceivers (Combo Ports 9-10)
The ES7510-XT provides two SFP ports
combined with RJ45 Gigabit Ethernet ports
(Ports 9-10). The SFP ports accept standard mini
GBIC DDM SFP transceivers that support
100BASE-FX/1000BASE-X.
To ensure system reliability, Comtrol
1.
Plug the SFP transceiver into the SFP fiber
transceiver.
2.
Connect the transmit channel to the receive
channel at each end.
3.
Check the direction/angle of the fiber transceiver and the fiber cable.
Note: This is a Class 1 Laser/LED product. Do not stare at the Laser/LED Beam.
The SFP port does not function until the fiber cable is linked to another active device. The SFP and
corresponding RJ45 ports work in an exclusive mode. Traffic sent or received through the SFP module has
priority thus no traffic is sent or received over the corresponding RJ45 connection. To use the RJ45
connection, remove the corresponding SFP.
Multi-Mode cables should not exceed 2KM and Single-Mode cables should not exceed 30km.
LED Descriptions
This subsection provides information about the ES7510-XT LEDs. You can also refer to
Page 129 for information about using the web user interface to remotely view LED information.
LED
LED Lit
LED Blinking
LED Off
Sys
System is ready
Firmware is uploading
System not ready
Power 1/2
Power is on
Not applicable
Power is not applied
RS (Ring
Status)
Green: Ring is
normal
Amber: Abnormal
Ring
Green: Ring with the wrong
port
Amber: The device's ring port
failed
Switch working in slave
mode
DO (Red)
Relay is active and
contacts have been
shorted
Not applicable
DO not activated
DI (Green)
High digital signal is
detected
Not applicable
DI not activated
LINK/ACT
Port is linked
Port active
Port link down or port
not connected
1000M
Port is linked at
1000Mbps
Not applicable
Not applicable
PoE
PoE is applying
power
Detecting
PoE disabled: power
output over current, a
cable short, or PoE is
disabled for that port
The SFP cage is 2 x1 design.