Comtrol ES7510-XT - Manual (Page 140)

140 - (Port) Interface Configuration RocketLinx ES7510-XT User Guide: 2000571 Rev. D
Configuration Using the Command Line Interface (CLI)
(Port) Interface Configuration
When you type interface IFNAME in Global Configuration mode, you can access Interface Configuration mode.
In this mode you can configure port settings.
The port interface names for the Fast Ethernet ports are fa1 through fa7. The port interface names for Gigabit
Ethernet port are gi910.
Type the interface name, for example fa1, when you want to enter certain interface configuration mode. Type
the following commands and press the Enter key:
• exit to return to Privileged EXEC mode.
• ? to see the command list.
• list to review the Interface Configuration mode commands and corresponding options. The following list is
the available commands for the Port Interface Configuration mode.
For the complete list of commands and options, refer to Port Interface Configuration Mode on Page 202.
Switch(config)# interface fa1
Switch(config-if)#
acceptable Configure 802.1Q acceptable frame types of a port
auto-negotiation Enable auto-negotiation state of a given port
description Interface specific description
dot1x IEEE 802.1x standard access security control
duplex Specify duplex mode of operation for a port
end End current mode and change to enable mode
ethertype Ethertype
exit Exit current mode and down to previous mode
flowcontrol Set flow-control value for an interface
garp General Attribute Registration Protocol
ingress IEEE 802.1Q ingress filtering features
lacp Link Aggregation Control Protocol
list Print command list
loopback Specify loopback mode of operation for a port
mdix Enable mdix state of a given port
mtu Specifies the MTU on a port
no Negate a command or set its defaults
poe Configure Power over Ethernet
qos Quality of Service (QoS)