Toshiba, 7 pattern frequency group parameters – Toshiba Q-Flowsaver II User Manual
Page 51
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TOSHIBA
9.7
PATTERN FREQUENCY GROUP PARAMETERS
FORWARD/REVERSE ROTATION SELECT (ITEM 1) - Use this function to select
between a forward or reverse motor rotation.
PRIORITY OF RR TERMINAL INPUT (ITEM 2) - Use this function to activate the
terminal, either IV or RR, into which the analog reference signal will be input.
MODE FOR PATTERN RUN (ITEM 3) - Use this function to select where the start
command will come from.
TIME UNIT FOR PATTERN RUN TIME SELECT (ITEM 4) - Use this function to select
the time units to be used in the pattern run.
QUANTITY OF PATTERN RUN CYCLES (ITEM 5) - Use this function to setup the
number of times that a pattern run is to be repeated.
PATTERN #1 RUN TIME (ITEM 6) - Use this function to set the run time of the preset
speed frequency SR1.
PATTERN #1 DRIVE CHARACTERISTIC (ITEM 7) - Use this function to select the type
of run for preset speed frequency #1. The selection can be a forward or reverse run,
using either ACC/DEC #1 or ACC/DEC #2.
PATTERN #2 RUN TIME (ITEM 8) - Use this function to set the run time of the preset
speed frequency SR2.
PATTERN #2 DRIVE CHARACTERISTIC (ITEM 9) - Use this function to select the type
of run for preset speed frequency #2. The selection can be a forward or reverse run,
using either ACC/DEC #1 or ACC/DEC #2.
PATTERN #3 RUN TIME (ITEM 10) - Use this function to set the run time of the preset
speed frequency SR3.
PATTERN #3 DRIVE CHARACTERISTIC (ITEM 11) - Use this function to select the type
of run for preset speed frequency #3. The selection can be a forward or reverse run,
using either ACC/DEC #1 or ACC/DEC #2.
PATTERN #4 RUN TIME (ITEM 12) - Use this function to set the run time of the preset
speed frequency SR4.
PATTERN #4 DRIVE CHARACTERISTIC (ITEM 13) - Use this function to select the type
of run for preset speed frequency #4. The selection can be a forward or reverse run,
using either ACC/DEC #1 or ACC/DEC #2.
PATTERN #5 RUN TIME (ITEM 14) - Use this function to set the run time of the preset
speed frequency SR5.
PATTERN #5 DRIVE CHARACTERISTIC (ITEM 15) - Use this function to select the type
of run for preset speed frequency #5. The selection can be a forward or reverse run,
using either ACC/DEC #1 or ACC/DEC #2.
9 - 1 0