2 operating panel keys and functions (cont'd), Read, Write – Toshiba Q-Flowsaver II User Manual

Page 28: Clear, Reset, Toshiba, Read write, Clear reset

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TOSHIBA

6.2 Operating Panel Keys and Functions (cont'd)

Keys and Functions

Key disables

RUN

STOP

commands until either the

AUTO

MANUAL

key is pressed. Display reads "OFF". Motor coasts to a stop if key is pressed

while motor is running

Disables manual control and turns the manual control LED off; drive will accept

commands from terminal strip connector or computer input only.

READ

WRITE

This key is used to scroll through the system parameters (see page 7-2), read

data from within the group or setup parameters, write data changes into the

non-volatile memory. System status information is available while drive is

running.

Key used to scroll through the parameter groups and returns to frequency

setting if in any other mode.

CLEAR

RESET

When data changes have been made in error, this key will allow user to clear

data back to data = 0 (if allowed). Also resets trips, or returns to frequency

mode.

This key stops the drive in manual mode. The manual mode stop can be

programmed to coast or decelerate to a stop. Will cause the drive to trip and

coast in any other mode. Can be used as an emergency stop in any mode.

Allows access to setup parameters only and will automatically return to

frequency mode after all parameters have been stepped through.

6 - 2