0 pwb layout, jumpers, and terminal connections, 1 control/driver board for q2-2035 through q2-2330, Pwb layout, jumpers, and terminai connections -1 – Toshiba Q-Flowsaver II User Manual

Page 19: Toshiba

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TOSHIBA

5.0

PWB Layout, Jumpers, and Terminal Connections

5.1

Control/Driver Board for Q2-2035 through Q2-2330

The following pictorial shows a layout of the major components located on the

control/dhver board VF3B-0100.

Note:

Potentiometer

RH1

is used for control power supply stabilization. This adjustment is

factory set and any

ADJUSTMENT BY THE USER SHOULD NOT BE ATTEMPTED.

Potentiometer

RH2

is used for voltage detection level bias. This adjustment is factory

set and any

ADJUSTMENT BY THE USER SHOULD NOT BE ATTEMPTED.

CPI, CP2,and CP3 are service testpoints.

Do not adjust JP3 and JP10.

Charge LED indicates charged capacitors.

DO NOT TOUCH internal parts if lighted.

5 - 1