Toshiba Q-Flowsaver II - Manual (Page 36)

TOSHIBA
7.2 System Parameters Adjustment Range and Factory Settings (cont'd)
PARAMETER
DISPLAY
ITEM
NO.
PARAMETER
DESCRIPTION
ADJUSTMENT
RANGE
FACTORY
SETTING
REFERENCE
PAGE
• n n r
. r . 1 r U
PATTERN FREQUENCY GROUP PARAMETERS (cont'd) * *
• 1 n r
• U U L I
20 Jog frequency 0.0 - 20.0 Hz 5.0 Hz 9-11
• 1 r 1 n
• L I . _ / L 1
21 Jog stop select 0: Deceleration stop
1 : Coast to stop
2: DC Injection stop
0 9-11
• r r /
. ' ~ - 1 L
22 Start-up frequency 0.0 - 10.0 Hz 0.0 Hz 9-11
• r
, I , / I J 1 1
23 Run frequency 0.0 Hz - FH 0.0 Hz 9-11
• r L ' U r
. ' ' J
J
24 Run frequency hysteresis 0.0 Hz - FH 0.0 Hz 9-12
Parameters are alternately exhibited from setup menu by alternately pressing
SETUP
key. Value of parameter can be read by pressing READ/WRITE key. Value can be
changed by continued pressing of "up" or "down" key. When desired value is reached
press the
READ/WRITE
key to store new value.
Group parameters are exhibited from group parameter menu by pressing PRG key.
When the desired group parameter is reached, individual parameters within the group
can be exhibited by alternately pressing the "up" or "down" key. Value of exhibited
parameter can be read by pressing READ/WRITE key.
Value of exhibited parameter
can be changed by continued pressing of "up" or "down" key. When desired value is
reached press the
READ/WRITE
key to store new value.
When P.SEL (mode for pattern run) is set to 0; pattern run times (Pt.It through Pt.7t)
and pattern run selections (Pt.1 through Pt.7) will be skipped when scrolling through
the Pattern Frequency Group Parameters.
7 - 6