beautypg.com

Cleaning the shuttle race, Cleaning the shuttle area, Replacing shuttle assembly – Kenmore 385.15512 User Manual

Page 72

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Cleaning the Shuttle Race

This area must be kept free of dust, lint and
occasional tangled thread. Clean the shuttle race area
about every three months

• Cleaning the shuttle area

0 Bobbin case

(D Levers

(D Shuttle race cover

@ Shuttle

(D Shuttle race

(g) Center pin on the shuttle

1. Raise the needle bar to Its highest point and remove the

bobbin case0.

2 Push shuttle race levers @ aside. Lift shuttle race

cover 0 and take shuttle 0out.

3 Clean the shuttle race © with a lint brush.

4 Put a drop of oil on the center pin of the shuttle © and

shuttle raced). Do not over oil

• Replacing shuttle assembly

0 Levers

0 Shuttle race cover

0 Shuttle

0 Shuttle race

0 Center pin on the shuttle

© Shuttle driver

0 Pointed hook

® (Oil here)

1. Turn handwheel so that shuttle driver © is forming half

moon on the left side of the machine,

2. Hold shuttle ® by center pin 0 and position shuttle so as

to form a half moon on the right side. The pointed hook ®

will be on the bottom.

3.

Place shuttle race cover 0 into place over shuttle
assembly,

4. Snap the levers © back into the original position.

64