Section vii. buttonhole, Buttonhole, Starting to sew – Kenmore 385.15512 User Manual
Page 66: Elio
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION VII. BUTTONHOLE
Buttonhole
Stitch selector:
Elio
(D Stitch length;
Blue zone
(D Needle thread tension:
1 to 5
@ Presser foot:
Sliding buttonhole foot
(D
■
PATTERN
E
LENGTH
C=:
Depending on your preference, you may adjust stitch density
within the blue zone on the stitch length control
* For more density, turn the stitch length control
toward " 0",
(T) Fine stitches for lightweight fabrics.
* For less density, turn the stitch length control
toward" 1
(D Coarse stitches for heavyweight fabrics.
NOTE; Always check a buttonhole on a scrap of
fabric to make sure the adjustment satisfies you,
* Starting to sew
Carefully mark buttonhole length on fabric.
Place the fabric under the foot with the buttonhole
marking running toward you
LENGTH
Move the slider (A) toward you so that the top mark
(C) on the slider meets the start mark (B) . Line up
the markings on the foot with the top mark on the
fabric. Lower the presser foot.
NOTE: The markings on the slider are engraved in
centimeters
’ur
B
Set the stitch selector at [] . Sew forward until you
reach the front marking of your buttonhole. Stop
sewing at a left stitch.
58