Kenmore 385.15512 - Manual (Page 14)

SECTION II. GETTING READY TO SEW
Connecting Machine to Power Supply
Ф Power supply plug (2) Power switch
(D Outlet @ Machine socket
(D Machine plug © Light bulb
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power.
1, Turn off the power switch (5).
2 Insert the machine plug (|) into the machine socket (4).
3- Insert the power supply plug© into the outlet (3),
4, Turn the power switch ©to turn on the power and sewing
light©
For Your Safety
* While in operation, always keep your eyes on the sewing
area Do not touch any moving parts such as the thread
take-up lever, handwheel or needle
* Always turn off the power switch and unplug from the
power supply;
- When leaving the machine unattended.
- When attaching or removing any parts
- When cleaning the machine.
* Do not place anything on the foot control, when not sewing.
Operating Instructions:
"For appliances with a polarized plug (one blade
wider than the other). To reduce the risk of electric shock,
this plug is intended to fit in a polarized outlet only one way
If it does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install the
power outlet. Do not modify the plug in any way."
"Foot Controller Model YC-482J orTJC-150 is used with
Sewing Machine Models 385,15512XXX."
XXX - represents numbers 000 through 999.
Controlling Sewing Speed
Sewing speed can be varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.