Kenmore 385.19005 - Manual (Page 9)

SECTION 11. GETTING READY TO SEW
Connecting Machine to Power Supply
(T) Power supply plug
(g) Power switch
(I) Outlet
© Foot control
(5) Foot control plug
(f) Machine plug
(7) Machine sockets
1 T u r n off the power switch Insert the foot control plug
(f) and machine plug (§) into the machine sockets (|)
2, Insert the power supply plug (© into the outlet (|,)
3. Tur n the power switch (I) to turn on the power and
the sewing light.
Note:
»if you turn off the power switch, wait 5 seconds before
turning it on again
Before Using Your Sewing Machine
Before using your sewing machine for the first time, place a
waste fabric under the ptesser foot and run the machine
with thread for a few minutes. Wipe away any oil which may
appear.
For Your Safety
* While in operation, always keep your eyes on the sewing
area. Do not touch any moving parts such as the thread
take-up lever, handwheel or needle.
* Always turn off the power switch and unplug from the
power supply:
«When leaving the machine unattended,
«When attaching or removing any parts,,
«When cleaning the machine,
* Do not place anything on the foot control, when not
sewing.
Polarized Plug
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way If the plug
does not fit in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install the proper outlet
Do not modify the plug in any way.