beautypg.com

Stabilizer, Types of stabilizer, Usage – Kenmore 385.19005 User Manual

Page 57: Adhesive (iron-on) stabilizer

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

stabilizer

To obtain the best quality embroidery, it is important to use

stabilizers.

Types of Stabilizer

«Tear-away stabilizer

Tear-away stabilizer is made from a fiber that will tear
easily Use tear-away stabilizers for stable woven fabrics.
After stitching, tear away the stabilizer so that the small
portion left in the back of the stitching will not affect the

wear.

• Iron-on stabilizer

Iron-on stabilizer is an adhesive type stabilizer for knits

and all kinds of unstable fabrics. Fuse it to the wrong side
of the fabr ics with an iron

*> Cut-away stabilizer

Cut-away stabilizer is a non-woven fabric that does not
tear . Cut the excess portion after stitching Use cut-away
stabilizers for knits and all kinds of unstable fabrics,

® Water soluble stabilizer

Water soluble stabilizer will dissolve in water. Use this
stabilizer for cutwork or lace embroidery, and also for the
right side of looped fabrics such as towel to avoid loops

coming through the embroidery,

o Sticky stabilizer

Sticky stabilizer is a sticky paper used for securing a small
fabric or work that cannot be secured in the hoop. It is

also used for velvet and other napped fabric that would be
permanently marked by the hoop.

Usage:

• The stabilizer should be attached to the wrong side of

fabric,

» More than one layer may be required,
» For firm fabrics, you may place a thin paper under the

fabric,

• Non-adhesive stabilizer should be used when

embroidering fabric which cannot be ironed or for
sections which are difficult to iron,

“ Cut the stabilizer larger than the embroidery hoop and set

it on the hoop so that the entire piece is fastened with the
hoop to prevent looseness of the fabric.

Adhesive (iron-on) Stabilizer

Place the wrong side of fabric ® and the glossy side of the

stabilizer (

2

) together. Fold up a corner of the stabilizer (3,)

and fuse it with an iron.

® Wrong side of fabric
(2) Stabilizer
d) Corner of the stabilizer

Notes:

»Fold up a corner of the stabilizer, to make it easier to

peel off the excess stabilizer after stitching.

■> Ironing temperatures vary depending on kind of

adhesive type stabilizer.