Thread cutter, Changing needle, Changing presser foot – Kenmore 385.19005 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Thread Cutter
(T)
Thread cutter
You do not need a pair of scissors to cut threads after
sewing. Just use the built-in thread cutter 0.
Changing Needle
Ф
Flat side
Ф Needle clamp screw
Ф Needle clamp
Ш Turn off the power switch.
Raise the needle to its highest position by turning the
handwheel counterclockwise, toward you, and lowering
the presser foot. Loosen the needle clamp screw ® by
turning it counterclockwise Remove the needle from the
needle clamp ф),
S] Insert a new needle into the needle clamp ® with the
flat side
(D
to the rear. When inserting the needle into
the needle clamp (3), push it up as far as it goes Tighten
^ the needle clamp screw ф firmly by turning it clockwise
Ш To check for a good needle, place the flat side of the
needle onto something fiat (needle plate, glass, etc,).
The gap between the needle and the flat surface should
be consistent. Never use a bent or blunt needle.
A damaged needle can cause permanent snags or runs
in knits, fine silks and silk-like fabrics
Changing Presser Foot
0 Snap-on button (red button)
0 Groove
0Pin
9 To remove
Raise the needle to its highest position by turning the
handwheel counterclockwise Raise the presser foot, and
press the red button 0 on the back of the foot holder,
»To attach
Place a selected pr esser foot so the pin (|) on the foot lies
just under the groove
CD
on the foot holder. Lower the
presser bar to lock the foot in place.