Kenmore 385.19005 - Manual (Page 44)

Corded Buttonhole
(i) Stitch pattern:
!'|) Needle thread tension
(|) Presser foot R;
® Pressure dial 12
1 to 5
Automatic buttonhole foot
3
Use the same procedure as the square buttonhole
procedure,
* Set the stitch width to match the thickness of the cord
used.
» To sew
II] With the buttonhole foot raised, hook the filler cord on
the spur at the back of the buttonhole foot,
Bring the ends toward you under the buttonhole foot,
clearing the front end.
Hook the filler cord into the forks
(I)
on the front of the
automatic buttonhole foot to hold them tight.
Lower the needle into the garment where the buttonhole
will start, and lower the foot,
n j Spur
(2) Forks
IT]
Press the start/stop button and sew the buttonhole
Each side of the buttonhole and the bartacks will be
sewn over the cord.
Remove the fabric from the machine, and cut the sewing
threads only
(1) Needle thread (Top thread)
(A) Bobbin thread {Bottom thread)
111 Pull the loose ends of the filler cord to tighten it..
Tie the ends in a knot, or thread them through a hand­
sewing needle. Draw them to the wrong side of the fabric
and knot .
39