Bobbin winding – Kenmore 385.19005 User Manual

Page 19

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Bobbin Winding

Note:

Set the speed control lever at its fastest position for
bobbin winding,

d) Upper thread guide
(2) Bobbin
(¿) Bobbin winder spindle

D Guide the thread around the upper thread guide (T).

2] Insert the thread through the hole on the bobbin (f),

threading from the inside to the outside. Put the

bobbin on the bobbin winder spindle d),

U Push the bobbin winder spindle (|) to the right

With the free end of the thread held in your hand,

depress the foot control, Stop the machine when

the bobbin has made a few turns, and cut the

thread close to the hole on the bobbin,

|] Depress the foot control again. When the bobbin is

fully wound, release the foot control and return the

bobbin to its original position by moving the spindle to

the left. Cut the thread as shown

Note:

For safety pur poses, the machine will stop automatically
2 minutes after the start of bobbin winding