beautypg.com

Threading the machine – Kenmore 385.19005 User Manual

Page 21

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Threading the Machine

»Threading the machine

*■ Raise the thread take-up lever to its highest position by

turning the handwheel counterclockwise

* Raise the presser foot lifter
* Place a spool on the spool pin, with the thread coming

off from the bottom toward the front of the sewing
machine

¡T]

Draw the end of the thread around the upper thread guide

in While holding the thread near the spool, draw the end of

the thread down around the check spring holder.

lli Firmly draw the thread up to the take-up lever, and down

into the take-up lever eye.

SI Pass the thread behind the lower thread guide on the left.

11]

Slip the thread in the needle bar thread guide on the left

Thread the needle from front to back, or use the built-in
needle threader

• Built-in needle threader

S) Knob
@ Hook

Q] Raise the needle to its highest position. Push down the

needle threader knob

(I)

as far as it will go.

The hook comes out through the needle eye from
behind,

El

Paying close attention to the needle point, draw the

thread around the guide and under the hook (E,

IE Release the knob slowly while holding the thread end

with your hand. A loop of the thread is pulled up through
the needle eye,

I

Note:

j The needle threader can be used with a #11 to #16

I

needle, or a #11 Blue needle,

i

Thread size 50 to 90 is recommended.