beautypg.com

To attach the embroidery hoop to the machirie, To attach embroidery foot p, Thread holder – Kenmore 385.19005 User Manual

Page 59

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

To Attach the Embroidery Hoop to the
Machirie

Turn the attaching knob (T) so it is parallel with the hoop,

and set it on the carriage

Attach the hoop by fitting the pins

if)

into the carriage

holes (1), and turn the attaching knob

Ct)

clockwise to

secure the hoop,
(I) Attaching knob
©Pins
(|) Carriage holes

Caution:
<■ Always provide sufficient clearance for the embroidery

carriage behind your machine before embroidery
sewing,.

® Do not try to move the carriage by hand or touch the

carriage while it is moving,,

® Make sure to return the carriage to the home position

before turning off the power switch (see page

57

),

To Attach Embroidery Foot P

(Tj Embroidery foot P

Q] Loosen the thumbscrew and remove the foot holder to

the rear.

tl] Attach Embroidery foot P (p to the presser bar from

behind,

Ij] Tighten the thumbscrew securely with the screwdriver.

Thread Holder

To prevent the needle thread from becoming tangled, place
the thread end on the thread holder (D

Pass the needle thread through the hole on embroidery foot

P and draw it up to the thread holder.
Hang about 3/4" to

1

-

1/2

(2

to 4 cm) of thread from front to

back on the thread holder.

© Thread holder
(f.) Hole on embroidery foot P