beautypg.com

For your safety read before operating, Operating instructions, Modulex ext – AERCO Modulex EXT 1530 - 3060 User Manual

Page 59

background image

MODULEX EXT

1530, 1912, 2295, 2677, 3060 BOILERS

Installation, Operation & Maintenance Manual

FOR YOUR SAFETY READ BEFORE OPERATING

WARNING: If you do not follow these instructions, a fire or explosion may result

causing property damage, personal injury, or loss of life.

A. This appliance does not have a pilot light. It is equipped with an ignition device, which

automatically lights the burner. Do NOT try to light the burner by hand.

B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next

to the floor, as some gas is heavier than air and will settle on the floor.

C. Use only your hand to turn the gas ball-valve knob. Never use tools. If the knob will not

turn by hand, do NOT try to repair it, but rather call a qualified service technician. Force

or attempted repair may result in a fire or explosion.

D. Do not use this appliance if any part has been submerged under water. Immediately call

a qualified service technician to inspect the appliance and to replace any part of the

control system and any gas control device that has been submerged under water.

WHAT TO DO IF YOU SMELL GAS:

Do not try to light any appliance

Do not touch or operate any electric switch

Do not use any phone in the building

Immediately call your gas supplier from a neighbors phone or from

outside with your cell phone and follow the gas supplier’s instructions.

OPERATING INSTRUCTIONS

1.

STOP! Read the safety information above on this warning.

2. Turn off all electric power to the appliance.
3. Open the gas valve.
4. Check gas and water pressure.
5. Wait five (5) minutes to clear out any gas, then smell for gas, including near the floor.
6. If you smell gas, STOP! Follow the instructions “WHAT TO DO IF YOU SMELL GAS” that are

printed above in these warnings. If you do not smell gas, go to the next step.

7. Turn on all electric power to the appliance.
8. Turn the start-up switch (next to the E8 controller) to the ON position. Replace the control

access panel.

9. Set Thermostat to the desired temperature.
10. If the appliance will not operate, follow instructions to turn off the gas (see below), and then call

your service technician or gas supplier.

TO TURN OFF GAS TO APPLIANCE

1. Set the thermostat to its lowest setting.
2. Turn off all electric power to the appliance if service is to be performed.
3. Close the gas valve.


OMM-0095_0E

AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913

Page 59 of 138

GF-139

Phone: 800-526-0288

12/01/14