21 combustion air and ventilation openings, 1 insufficient ventilation and combustion air, Modulex ext – AERCO Modulex EXT 1530 - 3060 User Manual
Page 39

MODULEX EXT
1530, 1912, 2295, 2677, 3060 BOILERS
Installation, Operation & Maintenance Manual
The Inspection Port should be plugged with an appropriate plug (not included).
Figure 3-15: Installed Flue Exhaust Diameter Reduction Adaptor Kit
3.21 Combustion Air and Ventilation Openings
Provisions for combustion and ventiiation air must be made in accordance with
section 5.3, Air
for
Combustion and Ventilation, of the National Flue Gas Code, ANSI Z223.1/NFPA 54., or
Sections 7.2, 7.3 or 7.4 of CAN/CSA-B149.1-05, installation codes, or appilcable provisions of
the local building codes.
3.21.1 Insufficient Ventilation and Combustion Air
BOILER DAMAGE AND OPERATIONAL FAILURES may occur due to insufficient or improper
openings for combustion air and/or ventilation of the boiler room.
Provisions for combustion air and ventilation are always required, regardless of whether the
combustion air is taken from the outside (sealed combustion) or inside (room air used as
combustion air).
Insufficient ventilation of the boiler room can lead to high air temperatures. This can result in boiler
damage. Note the following:
•
Make sure that intake and exhaust openings are sufficiently sized and no
reduction or closure of any openings takes place.
•
When a combustion air or ventilation problem is not resolved, do not operate
the boiler.
When one expects contaminated combustion air (near swimming pools, chemical cleaning
operations, hair salons, etc.), sealed combustion operation is recommended.
INSTAL FLUE PIPING
TO ADAPTER WITH
RTV LIQUID
SILICONE AND
WORM-DRIVEN
HOSE CLAMP
FLUE VENT PIPE
ADAPTER ASSEMBLY
EUROPEAN TO AMERICAN
STANDARD FLUE ADAPTER
Test Nipple
should be
installed
within first
3 feet of
flue start.
3 feet
(914.4 mm)
OMM-0095_0E
AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913
Page 39 of 138
GF-139
Phone: 800-526-0288
12/01/14