6 boiler package contents, Modulex ext – AERCO Modulex EXT 1530 - 3060 User Manual
Page 24

MODULEX EXT
1530, 1912, 2295, 2677, 3060 Boilers
Installation, Operation & Maintenance Manual
avoid damage to the boiler during the removal.
4. To prepare the boiler for lifting by the hoist, remove panel covers from front, rear, right, left
and top (Panel 6).
5. Use the four hoist straps (Panel 5) as slings and place one under each of four boiler legs
ensuring that strap is located UNDER the cross bars of the frame as shown in Panel 6.
6. Ensure belts are placed correctly on all four boiler legs before attempting to lift it.
3.6 Boiler Package Contents
In the packaging, in addition to the boiler, you will also find the following contents:
ON THE LEFT HAND SIDE OF BOILER (UNDER PANEL)
•
CSD-1 manifold.
CARDBOARD BOX #1
•
Gasket between exhaust manifold and adaptor
•
Four (4) piping elbows, a piping tee, and plastic plug for
condenstate draining system
•
Hardware for assembling exhaust manifold
•
Three (3) sensors:
o
Remote temperature sensor
o
DHW Storage tank sensor
o
Outdoor temerature sensor
•
Electrical resistor kit for emergency operation
•
Combustion sampling port for the flue
•
Metal plate and cable for power output
CARDBOARD BOX #2
•
European-to-USA vent adaptor
•
Two (2) gaskets for air intake and exhaust connections
•
One (1) 300mm diameter gasket
INSIDE CASING ON THE BACK OF THE BOILER
•
Two (2) pipes, each 39.3 feet (1 m) long for the
condensate draining system
ABOVE THE TOP COVER OF THE BOILER
•
A plastic bag containing:
o
This installation and user manual for the installer.
o
E8 controller instruction manual.
IN A SEPARATE BOX
•
Air intake adaptor for spiral ducting
•
Temperature & Pressure gauge
•
Flow Switch
•
Pipe adaptor (rubber)
CSD-1
Manifold
Box #2
Flue Parts
Page 24 of 138
AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913
OMM-0095_0E
12/01/14
Phone: 800-526-0288
GF-139