Cleveland Range inverter - Manual (Page 75)

Chapter 4 - Parameter Description [I/O]
69
average ranges from 0V to 10V. I/O-41 is used to
adjust the FM value.
[Frequency]
FM terminal outputs inverter output frequency.
The output value is determined by,
FM Output Voltage = (Output freq. / Max. freq.) × 10V × IO-
41 / 100
[Current]
FM terminal outputs inverter output current. The
output value is determined by,
FM Output Voltage = (Output current / Rated current) × 10V
× IO-41 / 150
[Voltage]
FM terminal outputs inverter output voltage. The
output value is determined by,
FM Output Voltage = (Output voltage / Max. output voltage) ×
10V × IO-41 / 100
[DC link vtg]
FM terminal outputs the DC link voltage of inverter.
The output value is determined by,
FM Output Voltage = (DC link voltage / Max. DC link voltage)
× 10V × IO-41 / 100
I/O-42: FDT (Frequency Detection) Level
I/O-43: FDT Bandwidth
These functions are used in I/O-44 [Multi-function
Output]. See [FDT-#] in I/O-44.
I/O-44: Multi-function Output define (MO-MG)
The open collector output works (Close) when the
defined condition has occurred.
Setting Range
Select Display
Description
FDT-1 0 Output frequency arrival detection
FDT-2 1 Specific frequency level detection
FDT-3
2 Frequency detection with pulse
FDT-4 3
Frequency detection with contact
closure
FDT-5
4
Frequency detection with contact
closure (inverted FDT-4)
OL
5 Overload detection
IOL 6 Inverter overload detection
Stall
7 Stall prevention mode detection
OV 8 Over voltage detection
LV 9 Low voltage detection
OH
10 Overheat detection
Lost Command 11 Lost command detection
Run 12 Inverter running detection
Stop
13 Inverter stop detection
Steady 14 Steady speed detection
-Reserved- 15 ~16 Reserved for future use
Ssearch
17 Speed search mode detection
-Reserved- 18 ~19 Reserved for future use
Ready 20 Inverter is ready status to run
Related Functions: I/O-44 [Multi-function Output]