Using the supplied software with a computer, Isystem requirements for photovu link & arcsoft, Connections – Panasonic PV-DV901 User Manual
Page 42: 2 turn your computer on, 3 set the palmcorder to vcr mode, 1 turn on computer and start up windows, 2 insert supplied cd-rom into the cd-rom drive, Software installation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3 о
Using the Supplied Software with a Computer
An image stored in the DV Cassette can be transferred to your Personal
Computer.
iSystem Requirements for PHOTOVU LINK & ArcSoft
• IBM PC/AT or compatible.
• Intel® Pentium® Processor: 266MHz or more
• Microsoft Windows®95/98/Me, Windows®2000
• CD-ROM drive (for installation)
• Mouse or other pointing device
PHOTOVU LINK:
• RAM: 16 MB or more
• 2MB minimum available hard disk space (for installation)
• 256 color monitor (full color recommended)
• RS-232C serial port (D-Sub 9-pin). An adaptor (D-Sub 9-pin male to a D-
Sub female) is required for a D-Sub 25-pin.
ArcSoft:
• RAM: 64 MB or more
• 220 MB minimum available hard disk space (for installation)
• High color (16bit) or more
USB Reader/Writer for SD Memory Card:
• Please refer to page 45, regarding the system requirements of USB
Reader/Writer for SD Memory Card.
^Connections
1 Connect the Palmcorder to your Computer (Windows) using
the RS-232C PC Connection Cable (supplied).
• Before connecting the Palmcorder to the Computer, make sure the
Computer is off to insure that images are transferred properly.
2 Turn your Computer on.
3 Set the Palmcorder to VCR Mode.
• For extended periods of use, it is recommended to use the AC Adaptor as a
power source,
• Refer to Computer or Windows operating instructions to identify which COM
port to be used for connection.
Software installation
(windows® SS/SS/Me, windows® 2000)
1 Turn on Computer and start up Windows.
2 Insert supplied CD-ROM into the CD-ROM drive.
• [Setup Menu] О appears.
3 Select the software to be installed from [Setup Menu].
• PHOTOVU LlNK(-> 43):
Software to transfer Image from your Palmcorder to your PC.
• USB Reader/Writer Device Driver (Ч 45, 46):
Software for USB Reader/Writer allows you to transfer images directly
off of the memory card into the computer
(Please refer to page 45 to install the driver of the USB Reader/Writer
for SD Memory Card.)
• ArcSoft software (-► 44):
“Panorama Maker^” 2000", “Photolmpression^“ 2000" and
"PhotoPrinter® 2000 Pro” are included .
4 Follow the instructions on the computer screen until the
installation is complete.
• Setup window will disappear when the installation is complete.
Note:
If a window does not appear automatically, click the “Start" Button on your
desktop and then click “Run”. When the “Run” Box is open, type in
“D:\lnstMenu.exe” and click “OK". (“D” applies when the CD-ROM drive is
drive D.)
42
For assistance, please cal!; 1 -800-211 -PANA(7262) or