Panasonic PV-DV901 - Manual (Page 13)

Lens Cap and Grip Belt
To protect the Lens surface, attach the Lens Cap. Adjust the length of the
Grip Belt to the size of your hand.
1 Attach the longer loop of the Lens Cap Cord to the Lens
Cap.
2 Attach the shorter loop to the grip belt.
3 Put your hand through the Grip Belt and adjust the length.
• The removed Lens Cap can be hooked onto the grip beltQ- (When you are
not recording, be sure to keep the Lens Cap attached to the Lens for
protection.)
Attaching the Shoulder Strap
We.recommend that you attach the Shoulder Strap before going out of doors
to record so as' to avoid dropping the Palmcorder.
1' Pass the tip of the Shoulder Strap through the Shoulder
Strap Holder on the Palmcorder and pull the Shoulder Strap.
2 Fold the tip of the Shoulder Strap, pass it through the
Shoulder Strap Length Adjuster, and pull it.
• Puil it out more than 1 inch (2 cm) Q from the Shoulder Strap Length
Adjuster so that it cannot siip off.
inserting a Cassette
When power is supplied to the Palmcorder, the cassette can be taken out
without turning the Palmcorder on.
1 Slide the [OPEN/EJECT] Lever 0 to the right and pull down
,to open the Cassette Compartment.
2 Insert a Cassette.
3 Close the Cassette Compartment and lock the Cassette
Compartment by pressing the [PUSH TO CLOSE] mark.
4 Close the Lower Cassette Compartment Cover.
• For other notes, see page 51.
■ Accidental Erasure Prevention
opening the accidental erasure prevention slider 0 on the cassette (by
sliding it in the [SAVE] arrow direction) prevents recording. To enable
recording, close the accidental erasure protection slider (by sliding it in the
[REC] arrow direction.)
13