CANOGA PERKINS 9145E10G NID Software Version 1.0 - Manual (Page 62)

9145E10G NID Software User’s Manual Diagnostics
VLAN Loopback
50
4.4.2 L2 Ping Generator
To set up the L2 Ping generator, type 3 and press Enter. The L2 Ping Generator screen (Figure
4-9) appears. Run the test by selecting 13. This will give you all the statistics that are described
below.
1. Destination MAC Address - MAC address that the LBMs will be sent to.
2. VLAN ID: - VLAN ID to be put in the LBM.
3. VLAN Priority: - Priority to be put in VLAN tag.
4. Ethertype: - Ethertype to be put in the LBM.
5. MD Level: - MD level to be put in the LBM.
6. Egress Port: - Port that the LBMs will be sent out.
7. Frame Count: - Number of LBMs to be sent out.
8. Frame Size: - Frame size of the LBM to be built, excluding 4 bytes CRC.
9. Frame Interval: - Time interval between two LBMs to be sent out. 0-500 in 10 ms inter-
vals may be specified. 0 indicates as fast as possible.
10. Frame Format: - Frame to be sent out in IEEE 802.3 or LLC SNAP format.
11. Start L2 Ping: - Start to send out the LBM and verify the responses. The status will be
shown. You may stop the testing by entering the ESC key.
Figure 4-8. L2 Ping Generator Statistics Screen
Canoga Perkins Corp. Ethernet Network Interface Device 04-JAN-2010
9145E10G-527-2-0 V01.00 F31 01:45:14
-------------------------------L2 PING GENERATOR-------------------------------
1) Destination MAC Address 00-00-00-00-00-00
2) VLAN ID (1-4094) 1
3) VLAN Priority (0-7) 0
4) Ethertype (4 Hex digits) 8902
5) MD Level (0-7) 7
6) Egress Port Net
7) Frame Count (1-99999999) 1
8) Minimum Frame Size (60-9996) 60
9) Maximum Frame Size (60-9996) 1514
10) Incremental Size (0-256) 0
11) Frame Time Interval (0-500 10ms) 0
12) Frame Format IEEE 802.3
13) Start L2 Ping
Select[1-13]:
------------------------------------Messages-----------------------------------