CANOGA PERKINS 9145E10G NID Software Version 1.0 - Manual (Page 32)

9145E10G NID Software User’s Manual System Configuration
IP/SNMP Agent Configuration
20
3.1.4.2 Editing a Host IP
To Edit a Host IP, on the Trap/Notifdication Destination Table (Figure 3-7), type Edit (E), use
Space to select a Host IP address, and press Enter. The Edit Trap/Notification menu (Figure 3-
6.) opens.
1. Type in the Host IP address to add to the Trap/Notification Destination Table, and press
Enter.
2. Enter the Trap/Notification Port, the default value is 162 for regular SNMP managers, 163
should be for CanogaView. Any port numbers from 1 to 65535 can be used to receive
traps. Check with your IT manager to ensure the port setting is correct.
3. Select the Notification Type for this SNMP host. Selections are: V1-Trap, V2c-Trap, V2c-
Inform, V3-Trap, and V3-Inform.
NOTE: Each Notification Type has a different configuration procedure. Fol-
low the specific procedure for the Notification Type selected.
4. If V1-Trap or V2c-Trap was selected (Figure 3-9.):
a. Enter the Community Name.
b. Press Enter.
c. Press Esc to return to the Trap/Notification Destination Table menu (Figure 3-7.).
Figure 3-9. V1-Trap or V2c-Trap Notification Type Parameter
Canoga Perkins Corp. Ethernet Network Interface Device 04-JAN-2010
9145E10G-527-2-0 V01.00 F31 01:45:14
---------------------TRAP/NOTIFICATION DESTINATION TABLE-----------------------
IP Address : 172.002.145.003
Trap/Notification Port : 162
Notification Type : V1-Trap (or V2c-Trap)
1. Community Name :
Enter the trap community name [32 characters maximum] -
-----------------------------------Messages-----------------------------------