CANOGA PERKINS 9145E10G NID Software Version 1.0 - Manual (Page 106)

9145E10G NID Software User’s Manual Link OAM
OAM Control
94
3. Link Events - Indicated that the 9145E10G can send and receive event notification
OAMPDU.
10.1.5 OAM Loopback Status
This function returns the status and states. There are four states available: No Loopback,
initiating Loopback, remote loopback, Terminating loopback.
10.1.6 OAM remote Fault
This function indicates whether a remote fault OAM PDU was sent by the peer to the
9145E10G.
10.1.7 OAM Admin State
This administrative state is what enables or disables OAM in the 9145E10G.
10.1.8 OAM Mode
There are two modes that can be configured in every port of the 9145E10G that are Pas-
sive and Active Modes. The passive mode allows to participate to the OAM but not the
capability to initiate any of the Link OAM functions such as Loopback or generate critical
Event while active mode allows you to run all teh OAM functions.
10.1.9 OAM Loopback Command
This command allows you to start or terminate an existing remote loopback in the
9145E10G.
10.1.10 Process Rx Loopback OAM PDU
This command allows you to control whether to process or ignore incoming OAMPDU.
10.1.11 Process Rx Link Fault Flag
This setting controls the actions taken upon reception of a Link Fault message from a
connected partner. If this object is set to Yes, the Link Fault will be processed the same as
Remote Fault and could trigger LLF.
10.1.12 FWD Critical Event
This setting controls whether or not a critical event is sent when the other port link goes
down. Information concerning operational status, maximum OAM Protected Data Units
(PDU) size, OAM revision, functions supported, loopback status, and remote link fault.