CANOGA PERKINS 9145E10G NID Software Version 1.0 - Manual (Page 27)

System Configuration 9145E10G NID Software User’s Manual
IP/SNMP Agent Configuration
15
4. Auxiliary VLAN Number - Sets Auxiliary IP VLAN ID number (between 0 and 4094).
Default is 0.
5. Allow Any VLAN - Enable or Disable acceptance of any VLAN number. If Auxiliary VLAN
Tagging is Enabled and Allow Any VLAN is Disabled, only packets tagged with the Auxil-
iary VLAN Number are accepted. If Auxiliary VLAN Tagging is Enabled and Allow Any
VLAN is Enabled, then any VLAN can be used with the Auxiliary IP.
6. Aux IP Rate Limiting - Enable or Disable Auxiliary IP Rate Limiting. The rate limiting func-
tion is used to rate limit the traffic being received from the Aux IP. The Aux IP Rate Limiting
default setting is enabled. Rate limiting may be set to Disable when running a test, how-
ever, the setting will return to Enabled after five minutes. An on screen timer shows time
remaining until automatic enabling. To extend Disable Time beyond five minutes, disable
Rate Limiting again before Timer expiration.
Table 3-1. IP Diagnostic Function Capabilities
3.1.3 Host Table
The Host Table menu (Figure 3-5.), configures the 9145E10G to send and receive SNMP, FTP,
and Telnet traffic to the Managing Host IP address, and access from specific Telnet clients when
Telnet security is enabled (Figure 3-6.). Use the Host Access Table to configure access by each
host including access type and privileges (SNMP, FTP, Telnet).
3.1.3.1 Adding/Editing a Managing Host IP
To add a Managing Host IP, select Add (A) from the Host Access Menu. To edit an existing Man-
aging Host IP select Edit (E). To delete a Managing Host IP select Delete (D). The Edit Host
Access menu (Figure 3-6.) opens.
1. Enter the Managing Host IP address to add to the Host Access list and press Enter.
2. Enter the IP Mask Size (default value 32). To have an entire subnet access the
9145E10G, enter the mask size for the subnet.
3. Select a Telnet access value. Choices for Telnet access are: Telnet and SSH, Telnet Only,
SSH Only, or None.
4. Cycle through the FTP Access parameters FTP and SFTP, FTP Only, SFTP Only, or
None using the Space Bar. Press Enter to select the parameter.
Function Management IP Test IP Auxiliary IP
Ping
√ √ √
Latency & Jitter
√ √ √
Performance Maintenance (PM)
√ √
N/A
Service Availability Monitoring (SAM)
√ √
N/A