2 oam mode, 3 oam loopback command, 4 process rx loopback oampdu – CANOGA PERKINS 9145 NID Software Version 6.0 User Manual

Page 73: 5 process rx link fault flag

9145 NID Software User’s Manual

The World Leader in Fiber Optic Communications Systems

9.1.2 OAM Mode

To set OAM Mode to either Active or Passive mode:

1. Type 2 and press . The User Port column entry will be highlighted.

2. If you wish to change the User Port setting, use to change between Active and

Passive, then press to lock in the setting and move to the Extension Port column.

3. If you do not want to change the User Port entry, use to move the highlight to the

Extension Port entry. Use to change between Active and Passive, then press
to lock in the setting.

9.1.3 OAM Loopback Command

To set OAM Loopback Command to either Start Remote Loopback, End Remote Loopback, or
No Loopback:

1. Type 3 and press . The User Port column entry will be highlighted.

2. If you wish to change the User Port setting, use to change between Start

Remote Loopback, Stop Remote Loopback, or No Loopback, then press to lock
in the setting and move to the Extension Port column.

3. If you do not want to change the User Port entry, use to move the highlight to the

Extension Port entry. Use to change between Start Remote Loopback, Stop
Remote Loopback, or No Loopback, then press to lock in the setting.

9.1.4 Process Rx Loopback OAMPDU

To modify the Process Rx Loopback OAMPDU settings:

1. Type 4 and press . The User Port column entry will be highlighted.

2. If you wish to change the User Port setting, use to change between Yes and No,

then press to lock in the setting and move to the Extension Port column.

3. If you do not want to change the User Port entry, use to move the highlight to the

Extension Port entry. Use to change between Yes and No, then press
to lock in the setting.

9.1.5 Process Rx Link Fault Flag

To modify the Process Rx Link Fault Flags settings:

1. Type 5 and press . The User Port column entry will be highlighted.

2. If you wish to change the User Port setting, use to change between Yes and No,

then press to lock in the setting and move to the Extension Port column.

3. If you do not want to change the User Port entry, use to move the highlight to the

Extension Port entry. Use to change between Yes and No, then press
to lock in the setting.