CANOGA PERKINS 9145 NID Software Version 6.0 - Manual (Page 62)

9145 NID Software User’s Manual
52 The World Leader in Fiber Optic Communications Systems
7.2 Reset Configuration To Default
NOTE: Resetting Configuration to Default does NOT clear the entries in the
Static ARP Table.
To reset the configuration to the default settings, type 2 and press . At the bottom of the
Utilities menu after “Reset configuration with factory default values and reset module?”, type Y or
N and press to confirm. All values will be returned to factory settings and the system will
be reset. Log back onto the network i.a.w. the instructions in Chapter 1, then type
6, and press
to return to the Utilities Menu.
7.3 Change Password
To change your current password, from the Utilities menu, type 3 and press . The
Change Password screen (see Figure 7-2) appears.
8. Type in the current password and press .
9. Type in the new password and press .
10. Retype the new password and press .
Figure 7-2. Change Password Screen
7.4 VT100 Baud Rate
To change the VT100 baud rate, from the Utilities menu, type 4 and press . The baud
rate setting will be highlighted. Use to toggle between 9600 and 19200. Press
to confirm setting.
Canoga Perkins Corp. Ethernet Network Interface Device 04-Jan-1970
Model 9145-4 V06.29 F117 02:59:35
-------------------------------CHANGE PASSWORD----------------------------------
Please enter your current password : *****
Please enter your new password: *****
Please enter your new password again : *****
:------------------------------------Messages------------------------------------