CANOGA PERKINS 9145 NID Software Version 6.0 - Manual (Page 63)

9145 NID Software User’s Manual
The World Leader in Fiber Optic Communications Systems 53
7.5 Slip/PPP Baud Rate
To change the VT100 baud rate, from the Utilities menu, type 4 and press . The baud
rate setting will be highlighted. Use to toggle between 9600, 19200, 38400, 57600, and
115200. Press to confirm setting.
7.6 PING Generation
From the Utilities menu, type 6 and press . The PING Generation screen (see Figure 7-3)
appears. On the PING Generation screen, type the number of the entry you wish to modify and
press .
Figure 7-3. PING Generation screen
1. On the PING Generation screen, type 1 and press . Use to remove
existing Ping to Address and type in the desired address.
NOTE: A Test IP address must be entered on the Management IP Configura-
tion menu (see Figure 3-3) in order to have Test IP appear as a Ping
from Address selection.
2. On the PING Generation screen, type 1 and press . Use to toggle
through Tst IP, Mgr IP, Aux IP, and Auto Selection. Type to lock in selection.
NOTE: If Auto Selection is chosen, Test IP will be used to perform the ping
test. If a Test IP is not avialable, Aux IP will be used. If an Aux IP is
not available, then Manager IP will be used.
3. When finished setting up the PING Generation screen entries, type 7 and press
to start the PING test.
4. When the test is complete, press to return to the PING Generation screen. Press
again to return to the Diagnostics menu.
Canoga Perkins Corp. Ethernet Network Interface Device 04-Jan-1970
Model 9145-4 V06.29 F117 02:59:35
-------------------------------PING GENERATION----------------------------------
1) Ping to Address : 0.0.0.0
2) Ping from Address : Mgr IP 172.16.142.120
3) Ping Count : 5
4) Ping VLAN ID : 0
5) Ping Payload Size (40 - 1954) : 40
6) Ping DF Bit : Set
7) Start Pinging
Select [1-7]:
:------------------------------------Messages------------------------------------