BendixKing KMD 150 - Pilots Guide - Manual (Page 67)

MANUALLY INSERTING A WAYPOINT INTO A FLIGHT
PLAN AND MANUAL DIRECT TO
A Waypoint can be inserted into a flight plan by using a two step process
that is started by pressing Key 2 INSERT ITEM. The same process is
followed when Key 5 DIRECT TO is selected in Screen 38, Map Mode
when the joystick is not active and a Flight Plan is not running. The same
process is also followed when Key 5 DATABASE is selected in Screen
41A.
SELECTING DATA
SOURCE
This Screen shows a list
of data libraries and you
will find a cursor posi-
tioned over the word AIR-
PORTS. You can use the
joystick to move the
cursor up and down the
list of databases. Keys
3,4 and 5 only appear if
this Screen is called from
Screen 38 Map Mode as
a DIRECT TO.
When using an external GPS this screen can be accessed from screen
38, Key 5, DATABASE. If this screen is accessed this way, Key 5
changes to NEAR INTS. Pressing this key will display the ten nearest
intersections.
By moving the cursor you select the database that contains the item you
are looking for, whether to insert into your flight plan or to use as a
DIRECT TO destination. Once you have the cursor over the correct
database, touching Key 2, SELECT, will move you onto the next selec-
tion process, which is Screen 16 Item Selection.
As stated previously, Key 3, NEAR APTS and Key 4, NEAR NAVAID,
only appear if this Screen has been entered after performing a DIRECT
TO in Screen 38, Map Mode. For more information on the function of
these keys, please refer to the Ten Nearest under the NAV Menu
Screens Section in this manual.
As stated previously, Key 5, TEMP WPT, only appears if this Screen has
been entered after performing a DIRECT TO in Screen 38, Map Mode. If
you press Key 5, this will take you to Screen 15, which allows you to
enter a DIRECT TO point.
Rev 2 Oct/2002 KMD 150 Pilot's Guide
53
Flight Planning Screens
Screen 13: Database Selection Screen