BendixKing KMD 150 - Pilots Guide - Manual (Page 112)

98
Rev 4 Apr/2005 KMD 150 Pilot's Guide
VIEW LOGS
Engineering Log
This Screen can be used
to produce technical
engineering information
about the unit. Unit type,
serial number and build
date information were all
stored within the Non
Volatile Memory at the
time your unit was initial-
ized at the factory. The
version of the software in
use and the latest update
information are stored on
the database card.
The Total Hours Run
value is updated every minute. This can give you an indication of the
total time that the unit has been in operation. You can, however reset this
figure, using Screen 33. The Total Flight Hours is a value stored in
exactly the same way as Total Hours Run, the difference between these
two figures being due to the fact that Flight Hours are totaled only during
periods when the Ground Speed is above 30 knots. Last Flight data is
available only with the KMD 150. The Date and Start Time are logged
as soon as the Ground Speed exceeds 30 knots and the Stop Time is
logged whenever the Ground Speed drops back to less than 30 knots.
Key 2, GPS RX LOG, is available only on KMD 150 units and gives
access to the GPS Receiver Engineering Log Screen 31.
GPS Receiver
Information Log
Most of the information
on this Screen is tech-
nical engineering infor-
mation about the internal
GPS receiver circuitry.
The Total Fix Hours
figure increases only
during the periods when
the GPS receiver has a
2D or 3D fix. You can if
you wish also reset these
Setup Screens
Screen 30: Engineering Log Screen
Screen 31: GPS Receiver Information
Screen (Internal GPS Units Only)